技術參數特性 TECHNICAL CHARAERISTICS
1 、光學類 觀察放大倍率: 6 倍
Optics Magnification : 6x
物鏡直徑: 25mm
Objeive lens : 25mm
出瞳直徑: 4mm
Exit pupil diameter : 4mm
視 場: 122m / 1000m 或 133yad/1000yad
Field of view : 122m / 1000m & 133yad/1000yad
膜 系: 多層復合鍍膜
Te of coating : Fully multi-coated optics
棱鏡類型: 4 類屋脊棱鏡
Te of pri : Bak4 roof pri
調焦系統: 單目調焦
Focus system : Eyepiece focusing
2、激光類 激光類型: 1 類(人眼)
Range Finder Laser Te : Cl 1(eye safe)
激光波長: 905nm
Laser wavelength: 905nm
測程范圍: 5 ~ 700m
Measuring range : 5 ~ 700m
距離: 通常狀態&plun; 1m /yad
Accuracy : rmal condition &plun; 1m /yad
掃描模式: 有
Scan mode : Yes
單位轉換: 米制 / 碼制
Meters/Yards display : Yes
目標反射等級指示: 有
Target quality indicator : Yes
3 、其它 電池種類: CR2 型 3V 鋰電
3 、 Misc Battery : CR2 battery DC3V
電池欠壓指示: 有
“ Low Battery ” indicator : Yes
顯示器: 透過式液晶顯示器
Display : LCD indicator
總重量: 162 克
Weight : 162g
外形尺寸: 75 × 40 × 110 mm
Dimensions : 75 × 40 × 110 mm
使用說明書 OPERATION INSTRUIONS
1 、按下“ AION/ON ”電源鍵,打開電源。
1 、 Depress the power button “ AION/ON ” to turn the power on.
2 、按 下“ MODE ”模式鍵,切換選擇距離單位 M 米制或 Y 碼制。具有動態數據切換功能,即測回某一數據后, 按住 “模式”鍵,切換單位并自動轉換數據并實時顯示出來。
2 、 Depress the mode button to change “ Meters ” to “ Yards ” . Dynamic data switching funion receive the data, hold down the "mode" button, switch units and automatically convert data and real-time show.
3 、按下“ AION/ON ”執行鍵 1 次,即可開始測距 1 次,右上角有模擬激光發射的標志在循環閃爍,表示正在發射激光。測回的數據顯示在正下方,同時顯示目標反射質量的高低指示,共分 5 級,從左到右由 5 個小塊組成,小塊越多表示反射越強。脫靶時顯示“――――” 4 個短橫線,表示目標太遠無法測回。數據顯示會一直保持直到下次操作或者自動斷電為止。
3 、 Press the "AION / ON" button one time, and begin Ranging 1, the -right corner of a simulated laser flashes signs in the loop, said it is launching laser. The data show that measurement is in the bottom, also showed that objeive refleion of the level of quality instruion, is divided into five, from left to right by five all components, all refleion that the more the stronger. Distance show "----" 4 short horizontal line, that goal can t be measured too far back. Data show that will remain until the next operation or the power of automatically.
4 、按住“ AION/ON ”執行鍵不松開,則立即開始進行掃描連續測距,測量數據不斷地刷新顯示,直到 松開按鍵為止。
4 、 Hold down the "AION / ON" button n-release, immediately began to scan for location, continuously updated measurements show that up until the release button
5 、當電池快用完時,會在左上角顯示一個電池號,表示應該更換電池了。
5 、 When the battery is running low, in the upper left corner will display a battery symbol, that the battery should be replaced.
6 、在主界面下,電源將在操作的約 30 秒后自動斷電。
6 、 In the main interface, power supply will be operation automatically after about 30 seconds off.
注意事項 ATTENTION
直視太陽會造成眼睛性損傷。
1 、 Viewing the sun can cause permanent eye damage.
不要用本產品直接測試太陽。
2 、 Do t view the sun with this Range finder or even with the naked eye.








