TP型鋁電解電容器，是單向導針引出型式(105℃ 8000H)產品，性能穩定適用于開關電源、高端適配器、LED電源、程控交換機、電子整流器以及等電子線路。
參考標準APPLICABLE SPECIFICATION
本承認書參考JIS-C-5101-1 和JIS-C-5101-4 制定。
This approval sheetconsulted the institute of JIS-C-5101-1 and JIS-C-5101-4.
測試環境CONDITION OF TT
如果沒有其他規定，標準的測試、檢驗環境條件如下所示：
環境溫度：15℃~35℃
相對濕度：45%~75%
大氣壓力：86kpa~106kpa
如果對測試結果有異議，可以在以下條件測試：
環境溫度：20&plun;1℃
相對濕度：60%~67%
大氣壓力：86kpa~106kpa
Unls otherwise
specified, the standard range of atmospheric conditions for making measurements
and tts are as follows
Ambient temperature：15℃to 35℃
Relative humidity ：45% to 75%
Air prsure ：86kpa to 106kpa
If there may be doubt on
the rults, measurements shall be made within the following limits
Ambient temperature：20&plun;1℃
Relative humidity :60%
to 67%
Air prsure ：86kpa to 106kpa
存放環境StorageEnvironment
環境溫?: 5℃ ~ 35℃, 環境相對濕?: 75%以下 .
Store the
capacitor at a
temperature of 5℃to 35℃and at
a relative humidity of
ls than 75% .
存放環境?應有陽光直射,?宜高溫.
Store the
capacitor in low
temperature plac free
from direct sun
shine .
存放環境?能有鹽分?油含?高的霧氣.
Store the
capacitor in plac
free from oil
vapor?salt water
vapor.
存放在遠??氨氣??化氫?亞?酸?硝酸等有害氣體含?高的地方.
Store the
capacitor in plac
far from toxic
gas ( chlorine?ammonium?hydrogen sulfide?sulphurous acid?nitric acid ,
etc ) .
儲存環境?能有臭氧?紫外線或幅射.
Store the
capacitor in place
free from Ozone?ultraviolet ray or
radiation .
合 RoHSRoHScompliance
合歐盟RoHS的新標準，若客戶有要求，按照雙方簽訂的相關協議為準。
Accord with the latt standard of
RoHS,if customers have any special requirements,according to the
relevant agreements which signed by both parts.
使用須知Instructions
直流鋁電解電容只能使用在直流電路上,其性須標明.
DC aluminum electrolytic capacitors can only be
used in DC on the road, its polarity must be marked.
在電路回路中如不清楚或不明確線路的性時,則建議使用無性鋁電解電容.
In the circuit loop, such as clear or t clear
when the polarity of the line, it is recommended to use n-polarized
electrolytic capacitors.
鋁電解電容器的工作環境溫度不能過規定的使用溫度范圍.
Electrolytic capacitors is the operating
temperature can t exceed the specified temperature range.
鋁電解電容器應該儲存于低溫及干燥場所,如儲存期較長,則使用前應用額定電壓對其重新老練.
Electrolytic capacitors should be stored in low
temperature and dry place, such as the storage period is longer, the rated
voltage is applied before using them to re-experienced.
通過鋁電解電容器的紋波電流不應過其允許范圍，如果過了規定值，需選用耐大紋波的鋁電解電容器.
The ripple current through the electrolytic
capacitor should t exceed the allowable range, if more than the specified
value, the need to use a large ripple-ristant aluminum electrolytic
capacitors.
使用時鋁電解電容器的工作電壓不應過其額定工作電壓.
Use the operating voltage aluminum electrolytic
capacitors should t exceed its rated voltage.
電烙鐵等高溫發熱裝置應與鋁電解電容器之塑料外殼保持適當的距離,以過熱造成塑料管破裂.
Electric iron and other high-temperature heating
with aluminum electrolytic capacitors of the device should maintain an
appropriate distance from the plastic housing to prevent overheating caused by
plastic pipe rupture.
在焊接鋁電解電容器時,其焊接時間及焊接溫度不應過10秒鐘及260攝氏度.
In welding aluminum electrolytic capacitor, the welding time
and weld temperature should t exceed 10 seconds and 260 degre Celsius.
對引線、端子,如施加過規定的力,將會破壞鋁電解電容器的內部結構.
Of lead, terminal, such as applied exceeds the force will dtroy the
internal structure of aluminum electrolytic capacitors.
