日本日亞405nm 6868 365nm 平窗120石英玻璃片封裝  3D打印機固化燈

參數(shù)

 電流 Forward Current 700mA

電壓 Forward Voltage   3.5-3.9V

電功率 Power Dissipation 3.08W

光功率 Radiant Flux 800mW/cm2

峰值波長 Peak Wavelength 405nm

封裝尺寸：6868    6.8*6.8*1.9 L*W*H(mm)

詢問中文詳細規(guī)格書可以聯(lián)系我，先看原文件截圖

散熱和焊接使用注意事項，需要中文的直接聯(lián)系我簡妮15989862032

 Thermal Management
● The Absolute Maximum Junion Temperature (T J ) must not be exceeded under any circumstances. The increase in the
temperature of an LED while in operation may vary depending on the PCB thermal resistance and the density of LEDs on the PCB
embly. Ensure that when using the LEDs for the chosen application, heat is not concentrated in an area and properly managed
in the system/embly.
● The operating current should be determined by considering the temperature conditions surrounding the LED (i.e. T A ). Ensure that
when operating the LED, proper measures are taken to dissipate the heat.
● The following two equations can be used to calculate the LED junion temperature:
1) T J =T A +R θJA ?1?1W 2) T J =T S +R θJS ?1?1W
*T J =LED Junion Temperature: °C
T A =Ambient Temperature: °C
T S =Soldering Temperature (Die Heat Sink): °C
R θJA =Thermal Resistance from Junion to Ambient: °C/W
R θJS =Thermal Resistance from Junion to T S Measurement Point: °C/W